Recent content by EthanIsMelting

The rear speakers were taking the signal from the sub. Once the speakers were wired to all run off the font signal everything worked.

1/0 to the distribution block, then split as close to the components as possible. It makes for easier wire management and a cleaner build.

Some pioneer single slot. The settings say subwoofer output is on and is set to normal. I've tried it with the out reversed, and off. Dead amp seems like the only option at this point. All the head unit settings are correct. Small backstory, there was a kenwood amp and sub in the vehicle 3 weeks...

https://subbox.pro/en/ I used this site. Hopefully it works for you!

I did not do the HU install, so could the HU and speakers be wired in such a way that the sub wont play? I think I have tried everything. All my power is good. I've tried new RCA's, I tried a 3.6mm to RCA from my phone to the amp, I tried L2L and R2R, and L2R and R2L, I tried on input and...

I'll try switching out the wires to my sub. I dont know how to check coil phase, but I'll look into that. Thanks!

I changed the wire, so now my battery/ground and remote/ground reads 12v, but still no sound. I've already swapped out the RCA'S. Sub is stable at 2 ohms. The power out to the sub jumps around, but so does the unconnected set. The ohms from the amp connection to the sub reads 23, and the...

To the body I get 12.7v stable, to a different ground, and to the same one I'm using.

It sits around 7.5 when its off

Negative to terminal, I'll give put it to the chassis and update.

Hi, I just installed a Hifonics Brutus 1500watt Class Super D amp in my 1993 Wrangler. The amp turns on, but I do not get any sound from my sub (Skar 8"). When testing with a voltmeter my Remote/ground reads 12.5, but my Battery/ground reads 0. Do I need to replace the cable, or a fuse? I...