Recent content by MrPlebbian

I’ll try to lower the gain so I can change the crossovers. I’m a bit concerned because when the gain is low the bass goes with it. The only way for the whole system to come close to sounding like the old, much less capable sub is for the gain to be as high as it is. I think I’m just...

When I set the crossovers any higher or lower it clips extremely and will even completely panic shut off so I don’t really know what to do

Well I tried it but it instantly clipped so hard it cut off completely, which is part of the reason I’m so confused about why this sounds the same as the old setup.

Old on left and new on right. And the box here

I would love to try out how that sounds but unfortunately when I bought the sub I didn’t know what the dual voice coil configuration meant and just bought a dual 1ohm so the highest I can wire it is 2ohms

The bass boost is completely off and the high filter is at around 60-65hz and the low is at around 100-120hz from what I can feel when certain songs play. the voltage while the system is at full volume is 13.29v and drops to 13.18 on the lowest when the hardest pulls happen and the back battery...

So first off I’m extremely new to anything in the electrical/sound world and all I’ve done is off intuition and very small amounts of verification from a friend who works with sound equipment occasionally. Now on to the main topic. I used to have a 1500W Machete amp powering a Machete M12v2D2...