Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Setting amp to the proper settings
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="SlugButter" data-source="post: 8728527" data-attributes="member: 678073"><p>The low pass filter should be set at where your door speakers can’t go any lower, or cause rattles in the door panel. I like mine at around 80, but if the door speaker rattles i would do my HPF on my speaker amp at a higher HZ and raise my sub amp LPF respectively. In my work truck, I have my LPF at 100 and my high pass filter on 100 also. If I set my HPF at 80, the bass going through the speakers causes too much rattling in the door panel (partly because i have tools and junk in my door panel storage). If you don’t have a HPF for your door speakers, not much of what I just said matters.</p></blockquote><p></p>
[QUOTE="SlugButter, post: 8728527, member: 678073"] The low pass filter should be set at where your door speakers can’t go any lower, or cause rattles in the door panel. I like mine at around 80, but if the door speaker rattles i would do my HPF on my speaker amp at a higher HZ and raise my sub amp LPF respectively. In my work truck, I have my LPF at 100 and my high pass filter on 100 also. If I set my HPF at 80, the bass going through the speakers causes too much rattling in the door panel (partly because i have tools and junk in my door panel storage). If you don’t have a HPF for your door speakers, not much of what I just said matters. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Setting amp to the proper settings
Top
Menu
Home
Refresh