If a sub's voicecoil fails, it will usually drop impedance causing too much current to go back to the amplifier. The amplifier then protects itself by shutting down playback.q
Activity
No one is currently typing a reply...
Similar threads
Using a Y RCA to split signal from amp to amp to give both amps the signal they need from the HU and subs in different /separate enclosures tuned...
- Started by Aaron Johnson
- General Car Audio
Fully test it without the ACR-1. TBH it sounds like an amplifier issue. Try connecting your phone direct to the amp via a 3.5mm to RCA cable. If...
- Started by esb
- Wiring, Electrical & Installation
Have you checked the fuse block. With time, tight connections can loosen and cause failure. Refresh those contact points and test again. Remember...
- Started by Ruizbra
- Wiring, Electrical & Installation
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
- Started by William Melcic
- General Car Audio
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
- Started by RyanJ0022
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 15
- Views
- 1,843
- Last reply date
- Last reply from
- 1aespinoza
New threads
-
After market stereo wiringI'm having issues color coordinating my wire colors on my 05...- Started by Darrell Robinson
- Replies: 3
-
WANTED 4 gauge OFCLooking to buy some 4 gauge OFC. Let me know if you have...- Started by AnthonyO
- Replies: 1
-
Another VS ThreadLooking to go for a cheap SQL build in the back of my Jeep...
- Started by Blackout67
- Replies: 16
-
Running two pairs of component speakers activeHello everyone. I need some advice. I am considering...- Started by 6r33n3y3z
- Replies: 10
-
Im trying to hook up a 4 channel ampI currently have a stock head unit with stock amp with jbl...
- Started by William Melcic
- Replies: 2