?? Need to know about the quality of these 2 amps ??

  • 2
    Participant count
  • Participant list

BlancaLoca

Junior Member
I have 2 12' Pheonix Gold Radial SD competition subs. I need a 1000 watt + amp to push them. I recently bought a powerzone Crunch 1500.1 amp but am not sure if this will provide the good quality I am looking for. Also have had my eye on an O2/Q2 3000 watt amp but am not sure if this has good quality either.. also not sure if this will be too much to push these 2 12's. Not sure what the RMS rating is fo the subs but I was told I need a 1000 watt amp or better.

Also does anyone have any suggestions for a high quality amp that will push these subs and not blow a whole in my pocket...

Thanks for your help

Blane

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

So you have an 800 watt sub (1600 is a peak spec, ignore it) the SVR-10 - 800 RMS dual 2VC ohm wired in parallel for a 1 ohm load paired with an...
7
85
How I would approach it is install your new amplifier and start using it. Install a voltage gauge and if you see your voltage lowering then add...
4
181
While most Asian and African markets will identify Honda's small hatchback as the Jazz model, most Western regions will know the same model as the...
2
135
The Kappa's have a high sensitivity rating of 93 db so the X802-5 would be fine. A good high sensitivity 8" sub in a properly sized box would fit...
2
482

About this thread

BlancaLoca

Junior Member
Thread starter
BlancaLoca
Joined
Location
Largo, FL
Start date
Participants
Who Replied
Replies
1
Views
2,858
Last reply date
Last reply from
bunkrd you
1716159391521.png

Doxquzme

    May 19, 2024
  • 0
  • 0
Screenshot_20240520_000638_Adobe Acrobat.jpg

Dylan27

    May 19, 2024
  • 0
  • 0

New threads

Top